5
4.0 Setting up a Sky HD remote for TV control
The Sky handset can also be set up to control your TV. You will need to look up the four digit code
for the TV manufacturer found on this website: http://sky.uebv.com/
4.1 Press TV.
4.2 Press Select and Red until the LED ashes twice.
4.3 Enter the four digit code followed by Select.
4.4 Test by pressing TV followed by Ch+ or Ch- and also the Standby button.
4.5 If unsuccessful repeat using an alternative code given on the website.
5.0 Setting up a Humax RM-F01 for NetAmp volume
If you have purchased a Humax YouView Freeview receiver, or other model of Freeview receiver
then you will need to purchase the Humax RM-F01 remote control. These are widely available for
about £20.
The full instructions and IR code bank can be viewed here:
http://www.humaxdigital.com/rcu/rcucodelist_mdb1.3_gb.pdf
5.1 Press and hold Audio for three seconds until the button light remains on.
5.2 Enter the three digit code 044. The light will blink twice.
5.3 Press OK and the light will blink three times.
The volume up, volume down, mute and standby keys on the remote control will now operate the
NetAmp via a LIM or KPS-11. You must select the audio device rst as the remote control will not
use these volume codes when in PVR mode.
6.0 Setting up a Humax RM-F01 for TV control
The RM-F01 can also be set up to operate a TV and DVD player. Follow the same instructions for
the NetAmp volume in section 5.0 but using the TV source button or DVD and using the correct
three digit number for the manufacturer.
To Next Page
Loading...