8
9.0 Setting up a SkyQ IR remote
9.1 Hold down buttons 1 and 3 on the Sky Q remote (not touch remote) you should see red LED
ash twice.
9.2 Press ? (bottom right).
9.3 Press 0 2 9 7 each digit should respond with a ash on the red LED the last digit will give 2
ashes from the Red LED which will indicate that the code has been successfully stored.
9.4 Volume up, down and mute should now operate the NetAmp.
?
CH
VOL
MUTE
Volume up
Volume down
Mute
To Next Page
Loading...
