Why T.I.P. DRAIN 6000/36 is not discharging any liquid and the motor isn't running?
If your T.I.P. Water Pump isn't discharging liquid and the motor isn't running, here are a few things to check: * **No current:** Verify voltage presence with a GS-compliant device and check the plug's position. * **Thermal motor protection:** Let the system cool down and eliminate the cause. * **Blocked pump wheel:** Clear any blockage of the pump wheel.
What to do if my T.I.P. DRAIN 6000/36 Water Pump stops quickly due to thermal motor protection?
If your T.I.P. Water Pump stops shortly after starting due to thermal motor protection, it could be due to several reasons: * **Incorrect electrical supply:** Ensure the electrical supply matches the type plate information using a GS-compliant device to check the connection cord voltage. * **Blocked pump/intake:** Remove any blockages from the pump or intake openings. * **Viscous liquid:** The pump might not be suitable for the liquid, consider thinning it if possible. * **High liquid temperature:** Ensure the liquid temperature doesn't exceed the maximum admissible value. * **Dry running:** Eliminate the causes of dry running.
How to fix a T.I.P. Water Pump when the motor runs but no liquid is discharged?
If the motor of your T.I.P. Water Pump is running but no liquid is being discharged, consider these potential issues: * **Clogged intake openings:** Remove any obstructions from the intake openings. * **Clogged pressure line:** Clear any blockages in the pressure line. * **Air in pump body:** Start the pump several times to expel trapped air. * **Low suction level/Floating switch issues:** Ensure the minimum suction level is met, adjust the floating switch if necessary, and ensure it moves freely. * **Blocked/defective check valve:** Clear any blockages in the check valve or replace it if damaged.
Why is my T.I.P. DRAIN 6000/36 operating intermittently?
If your T.I.P. Water Pump is operating intermittently, there could be a few reasons: * **Pump wheel obstructed:** Remove any solid matter that might be obstructing the pump wheel. * **Mains voltage out of tolerance:** Ensure that the mains voltage matches what's indicated on the type plate.
What causes a T.I.P. DRAIN 6000/36 to not cut in or out?
If your T.I.P. Water Pump isn't cutting in or out, check the following: * **Floating switch movement:** Make sure the floating switch can move freely. * **Floating switch setting:** Correct the floating switch settings if they are incorrect.
Installation requires the device to remain disconnected from mains power.
Use a large diameter pressure line, ideally matching the pump outlet, to avoid friction losses.
Rigid pipes are recommended for stationary installations, with a check valve for preventing backflow.
Adjust the cut-in and cut-out levels by modifying the floating switch cable length.
Position the pump ensuring max. submersion depth is not exceeded and it sits on solid ground.
General| Brand | T.I.P. |
|---|---|
| Model | DRAIN 6000/36 |
| Category | Water Pump |
| Language | English |
To Next Page