T.I.P. MSC 3/3 M - User Manual

Questions and Answers

E
ebarajasJul 28, 2025
What to do if my T.I.P. MSC 3/3 M motor is running, but no liquid is being discharged?
- C
  Cheryl HallJul 29, 2025
  If your T.I.P. Water Pump's motor runs but doesn't discharge liquid, several issues could be the cause. First, check for and remove any clogs in the intake openings or the pressure line. Also, make sure there are no kinks or disturbances in the connection lines. Next, inspect the check valve (non-return valve) for blockages or damage; clear any blockages or replace the valve if needed. Ensure the intake inlets are fully immersed in the liquid. Finally, verify that the pump head isn't exceeding the specifications in the technical data; adjust the installation to ensure the suction height remains within the maximum value.
W
Wendy HallAug 4, 2025
Why does my T.I.P. MSC 3/3 M stop after a short time of operation?
- K
  Karen HartAug 5, 2025
  Your T.I.P. Water Pump might stop shortly after starting due to the thermal motor protection feature activating. This could be because the electrical supply doesn't match the type plate information; verify the voltage of the connection cord lines. Also, the liquid may be too viscous, consider thinning it if possible, or the pump may not be suitable for the liquid. The liquid's temperature might be too high, so ensure it doesn't exceed the maximum admissible value. Finally, the pump might be running dry; eliminate the causes of dry-running.
T
Tracy ChavezAug 13, 2025
What to do if my T.I.P. MSC 3/3 M Water Pump is not discharging any liquid and the motor is not running?
- T
  Tyler GreenAug 13, 2025
  If your T.I.P. Water Pump isn't discharging liquid and the motor isn't running, it could be due to several reasons. First, check for current using a device complying with GS (German technical supervisory authority) and verify the plug's position. If the thermal motor protection feature has been triggered, disconnect the pump, let it cool, and address the cause. If the capacitor is defective, contact customer service. Lastly, check if the pump wheel is blocked and remove any obstructions.
S
Stanley BruceAug 20, 2025
Why is my T.I.P. MSC 3/3 M Water Pump operating intermittently?
- D
  Daniel JacobsonAug 20, 2025
  Your T.I.P. Water Pump may operate intermittently due to several factors. Ensure the mains voltage matches what's indicated on the type plate. If the mains voltage is not within the tolerance indicated on the type plate, correct it. If the motor is defective, contact customer service.