Need help?Do you have a question about the T.I.P. WP 500 Plus and is the answer not in the manual?
General| Brand | T.I.P. |
|---|---|
| Model | WP 500 Plus |
| Category | Water Pump |
| Language | English |
Disconnect the unit from the mains before installation. Do not force single components while assembling as this may damage the unit.
Insert telescopic tube, mount spray jet, adjust flowrate, place pump indoors, ensure immersion, fix with suction cups, adjust height.
Rinse components like pump, tube, and jets under running water to remove dirt and limescale.
Clean rotor and pump body. Disassemble pump, wash parts under lukewarm water, clean with non-metallic brush.
Store appliance in a dry, frost-protected place after cleaning and drying carefully if not used for a long time.
Check for installation errors. Charts provide remedies for common faults with probable causes and solutions.
To Next Page
