T.I.P. DIO 45/13 fl ex

Questions and Answers

R
Ryan RamosJul 30, 2025
What to do if my T.I.P. Water Pump motor is running, but no liquid is being discharged?
- D
  danielleparkerJul 30, 2025
  If the motor of your T.I.P. Water Pump is running but not discharging liquid, several issues could be the cause. First, check for and remove any clogs in the intake openings or the pressure line. Also, try starting the pump several times to expel any air trapped in the pump body. Ensure that the minimum suction level is adequate and that the floating switch moves freely. If the floating switch is defective, please contact customer service.
K
Kimberly PittmanAug 5, 2025
Why does my T.I.P. Water Pump stop shortly after starting due to thermal motor protection?
- P
  pthompsonAug 5, 2025
  Your T.I.P. Water Pump might be stopping due to the thermal motor protection being triggered. This could be because the electrical supply doesn't match the type plate information; verify the voltage with a GS-compliant device. Other potential causes include blockages in the pump or intake openings, liquid that is too viscous (thin the liquid if possible), liquid temperature exceeding the maximum admissible value, or the pump running dry. Address these potential issues to resolve the problem.
K
kristopher90Aug 13, 2025
What to do if my T.I.P. DIO 45/13 fl ex is not discharging any liquid and the motor isn't running?
- T
  Tamara AlvaradoAug 13, 2025
  If your T.I.P. Water Pump isn't discharging liquid and the motor isn't running, check the following: 1. Ensure there is current by checking the voltage with a GS-compliant device and verify the plug's position. 2. If the thermal motor protection has triggered, disconnect the pump, let it cool, and eliminate the cause. 3. Check if the pump wheel is blocked and remove any blockage.
M
mary49Aug 20, 2025
What causes intermittent operation of T.I.P. DIO 45/13 fl ex Water Pump?
- A
  Angela HarrisAug 20, 2025
  Intermittent or irregular operation of your T.I.P. Water Pump can be caused by several factors. The pump wheel could be obstructed by solid matter; if so, remove the solids. Ensure that the mains voltage matches what is indicated on the type plate.

Summary

General safety information

Range of use

Technical Data

Scope of delivery

Installation

General installation information

General advice on installation procedures and protection.

Installation of the pressure line

Guidance on connecting the pressure line and riser pipes.

How to position the pump

Instructions for placing the pump in the container, including fastening.

Functioning of the floating switch

Explains how the floating switch controls pump operation.

Electrical connection

Putting into operation

Maintenance and troubleshooting

T.I.P. DIO 45/13 fl ex Specifications

General

Type	Submersible pump
Power consumption	450 W
Max. immersion depth	7 m
Max. particle size	5 mm
Cable length	10 m
Voltage	230 V
Frequency	50 Hz
Phase	1
Max. flow rate	13000 l/h
Flow Rate	13 m³/h
Power	0.45 kW