T.I.P. FlatOne 6000 INOX

Questions and Answers

C
Corey RamosJul 29, 2025
What to do if T.I.P. FlatOne 6000 INOX stops after short time?
- G
  Gina SpencerJul 29, 2025
  If your T.I.P. Water Pump stops shortly after starting due to the thermal motor protection, several factors could be at play. Ensure the electrical supply matches the type plate information, using a GS-compliant device to check the voltage, while observing all safety information. Debris might be blocking the pump or intake openings, so remove any obstructions. The liquid may be too viscous or too hot; thin the liquid if possible or ensure it's within the pump's temperature limits. Also, the pump may be running dry, so identify and eliminate the causes of dry-running.
A
Ashley PopeAug 5, 2025
Why is my T.I.P. Water Pump motor running but not pumping water?
- A
  Angela PetersonAug 6, 2025
  If the motor of your T.I.P. Water Pump runs but no liquid is being discharged, check for a few common issues. The intake openings or pressure line may be clogged; remove any obstructions. Air might be trapped in the pump body; try starting the pump several times to expel the air. Ensure the minimum suction level is met and the floating switch is correctly set and moves freely; for a defective switch, contact customer service. Also, inspect the check valve (non-return valve) for blockages or damage; clear any blockages or replace the valve if needed.
W
wrighttroyAug 13, 2025
How to fix T.I.P. FlatOne 6000 INOX that won't turn on or off automatically?
- W
  williamlindseyAug 13, 2025
  If your T.I.P. Water Pump isn't automatically turning on or off, the floating switch is likely the problem. Ensure the floating switch can move without any restrictions and that its settings are correct. If the floating switch is defective, contact customer service.
F
felicia96Aug 20, 2025
Why does my T.I.P. FlatOne 6000 INOX operate irregularly?
- C
  Christy MorrisAug 20, 2025
  If your T.I.P. Water Pump is operating intermittently, start by checking for solid matter obstructing the pump wheel and remove any you find. Also, ensure that the mains voltage matches what's indicated on the type plate. If these steps don't resolve the issue, the motor or pump wheel may be defective, and you should contact customer service.

Summary

General Safety Information

Range of Use

Technical Data

Installation

General Installation Information

General guidelines for installing the device, emphasizing safety and proper connections.

Installation of the Pressure Line

Instructions for connecting the pressure line, including adapter use and check valve fitting.

Stationary Installation

Recommendations for stationary setups, including pipe types and additional valves.

How to Set the Floating Switch

Guidance on adjusting the floating switch for automatic cut-in and cut-out levels.

Use as Low Suction Pump

How to Position the Pump

Electrical Connection

Putting into Operation

Maintenance and Troubleshooting

Warranty

How to Order Spare Parts

Service

T.I.P. FlatOne 6000 INOX Specifications

General

Type	Submersible pump
Max. immersion depth	7 m
Max. particle size	5 mm
Pump housing material	Stainless steel
Protection class	IPX8
Cable length	10 m
Voltage	230 V
Frequency	50 Hz
Weight	5.3 kg
Inlet/Outlet	1 1/4"