Specifications A-1
Appendix A
9250 SPECIFICATIONS (preliminary)
Input Characteristics
Number of Channels 2 with single-ended outputs; 1 with differential outputs
Connectors BNC
Impedance 50Ω, 75Ω, or 1MΩ
Coupling DC or AC
Damage Level 12Vp-p (-6V to +6V peaks)
Frequency Range DC to 15MHz (full power bandwidth), DC coupled, 50Ω input/output
impedance;
40kHz to 15MHz (full power bandwidth), AC coupled, 50Ω/75Ω input
impedance;
20Hz to 15MHz (full power bandwidth), AC coupled, 1MΩ input
impedance;
Output Characteristics
General
Connector BNC
Impedance
Single-Ended 50Ω, 75Ω, or 600Ω
Differential 600Ω
Coupling DC or AC
Protection Short-circuit, 10 seconds
Gain x10, fixed (can be ordered from factory with different gain setting.
Bandwidth may change with different gain configuration)
Polarity Output normal
Amplitude 0 to 20Vp-p into matching impedance (50Ω, 75Ω, or 600Ω); 0 to 40Vp-p
into high impedance
Square Wave Characteristics
Transition Time <22ns
Aberrations <7%
Sine Wave Characteristics
Small Signal
Bandwidth 30MHz, at 2Vp-p (-3dB)
Accuracy ±(3% of full-scale amplitude range + 25mV), Square wave at 1kHz
Flatness (10Vp-p) ±5% of amplitude to 1MHz; ±10% of amplitude to 15MHz
THD 0.1%, 10Hz to 100kHz
Harmonics <-50dBc, 100kHz to 5MHz
<-40dBc, 5MHz to 15MHz (10Vp-p)
General
Physical Size 2U, half-rack size
Power Requirements 85V to 265V, 47-63Hz, <25W
To Next Page
Loading...