13
DATE & TIME
5. Turn WiFi Off - Press and hold the WiFi/Mode button for 3 seconds. This will turn
off your WiFi and disconnect you from your mobile device.
Note: Buttons on your Tactacam will not work when connected to WiFi
DATE & TIME - AUTOMATIC
1. Your camera’s date and time are automatically set when you connect your
camera to the Tactacam app. Your Tactacam will also install a Text le on your SD
card that will allow you to manually set the date and time, if needed.
DATE & TIME - MANUAL
Your Tactacam will install a Text le on your SD card. This Text le will allow you to
set the date and time.
1. Simply connect your Tactacam to your computer with the supplied USB cord and
open up the text le located on the SD card.
2. Adjust the time and date on the text le. Save and close the le.
3. Eject your camera from the computer.
4. Remove your camera from the USB cord to apply the time and date settings.
See video tutorials at www.tactacam.com/support
To Next Page
Loading...
Need help?
General
