6
POWERING ON AND RECORDING
1. Push the Rec/Power button. You will feel the
camera vibrate 2 times and see a blinking green
light around the Rec/Power button. The green LED
must be blinking for the camera to be recording.
The process takes approximately 3 seconds.
NOTE: If light does not begin to ash, make sure
your SD card is installed, formatted, and not lled
with videos.
2. To pause your recording quickly push the Rec/
Power button. The camera will vibrate 1 time and
the green light will go solid around the rec/power
button.
3. With the camera paused, change the modes by
pushing the mode button.
4. To power your camera completely off push and
hold the Rec/Power button for 5 seconds.
5. The camera will automatically power off to save
battery when left in pause mode after 3 minutes.
To Next Page
Loading...
