TB7100 Installation Guide Installation 15
© Tait Electronics Limited March 2006
1.8.4 Cabling
We recommend that you route all cables to and from the base station along
the side of the cabinet so the cooling airflow is not restricted.
Cables should be well supported so that the connectors or terminals on the
base station and on the ends of the cables do not have to support the full
weight of the cables.
Cables must be routed so that they do not restrict the air outlets at the rear
of the base station.
1.8.5 Accessories
The base station can use the following accessories:
■ 219-03012-00 cable assembly to connect TB7100 to CMM card
■ T809-10-87xx power supply
■ TBBA03-01 wall mounting kit
■
TBBA03-02 duplexer kit
(mechanical configuration without provision for internal
AC power supply unit)
■ TBBA03-03 duplexer kit
(mechanical configuration with
provision for
internal AC power
supply unit)
■ TBBA03-04 TB7100 transit bracket kit
■ TMAA02-01 fist microphone
To Next Page
Loading...
Need help?
General
