Tuneup TOPA-SV-024 Test Unit 34
August 2004 © Tait Electronics Ltd
6 TOPA-SV-024 Test Unit
The TOPA-SV-024 test unit is used to test and maintain Tait Orca
portables (TOP) and TM9100 radios by providing an interface between
the radio, a test PC, and an RF communications test set.
The diagram below shows the front panel of the test unit.
6.1 Test Equipment Setup
The diagram on the following page shows how the test unit is connected to
the radio, the test PC, and the RF communications test set.
Note The test unit can also be connected to a T2000 radio using the
T2000-11 cable. Use with T2000 radios is not described in
this document.
6.2 Operation
This section explains the function of the TOPA-SV-024 test unit controls.
The procedure for using the test unit is described in the section of the
TM9100 Service Manual covering test equipment.
Figure 6.1 TOPA-SV-024 test unit