18 Installation Options TM9300/TM9400 Installation Guide
© Tait International Limited August 2020
2.5 Desktop Installation
The TMAA13 power supply enables you to use a mobile radio as a desktop
radio. The TMAA13 operates on an input voltage of 100–130VAC or
200–250VAC, depending on the model, and can be used with both 30-
50W and 25W radios. The mobile radio can be installed at a distance from
the power supply, or it can be mounted on top of the power supply using a
plinth. The following diagram shows the components included in each kit.
Refer to the TMAA13 Power Supplies User’s Guide (MMZ-00002-xx) for
full details.
Tait strongly recommends to use one TMAA13 power supply for each
radio. This prevents any issues caused by simultaneous transmissions.
Power Supply Kit
TMAA13
power supplymains cable
Plinth Kit
TMAA03-12: 30-50W radios
TMAA03-09: 25W radios
power cable
8.2ft (2.5m)
3 x screws
3 x washers
microphone clip
4 thumb screws plinth
U-cradle Kit
TMAA03-13: 30-50W radios
TMAA03-06: 25W radios
4 thumb screws
2 x screws
microphone clip
power cable
1ft (300mm)
U-cradle
To Next Page
Loading...
