Midian Encryption Programming and Service Manual Tait Orca Portable (TOP) Encryption 37
June 2006 © Tait Electronics Limited
Modify TOP PCB (top side)
1. Locate the can with large hole cut as shown
2. If there is no large hole in the can, cut carefully with sidecutters
where shown, and turn the edges in
3. Remove capacitor C567 using a hot air gun and tweezers
4. Remove component R646 using a hot air gun and tweezers, and
replace with 4K7 resistor (IPN 038-14470-00)
5. Remove component R4 using hot air gun and tweezers
1
2
5
3
To Next Page
Loading...
