Need help?Do you have a question about the Tait T2000 and is the answer not in the manual?
Details compliance with the European Union standard EN60950.
Discusses radio frequency energy limits and restrictions for use.
Explains EU regulations for radio equipment, including health, safety, and EMC.
Describes the intended use of the FM radio transceiver for PMR/PAMR services.
Provides information on where to find the Declaration of Conformity.
Details EU regulations for automotive radio equipment EMC.
Outlines FCC rules for RF emission limits to prevent interference.
Provides website links for product details and technical assistance.
Explains microprocessor control for fleet customization.
Instructions on how to turn the radio on and adjust volume.
Describes how to check and change the active channel on the radio.
Guides on selecting a channel and initiating a call.
Explains how the microphone and PTT key control transmit/receive modes.
Describes the transmit timer and its warning function.
How to respond to an incoming call and identify yourself.
Explains the mute functions and how to use the Monitor key.
Instructions on setting up and using the scan feature.
Details the dual priority scan feature available on the T2015II model.
Step-by-step guide to initiating a Selcall.
How the radio indicates and how to accept/reject a Selcall.
Explains how group calls are received and if a response is needed.
Details on how to send and receive emergency calls using the Selcall option.
Explains the economy mode for conserving battery power.
Provides guidance on checking power issues and contacting dealers.
Step-by-step instructions for removing the radio from its cradle.
Lists all parts included in the T2000II Radio Kit.
Details the components included in the installation kit.
Lists the recommended tools for installing the radio.
Guidance on inspecting the vehicle and planning the radio installation.
Advises on safe mounting positions and preventing interference with vehicle systems.
Instructions on how to disassemble the radio cradle.
Details on marking, drilling, and securing the mounting bracket.
Instructions on how to reassemble the radio cradle.
Explains antenna installation requirements and initial steps.
Covers connecting external speakers and the power cable.
Details on connecting external wires and installing the remote control head.
Explains the grounding requirement and mounting considerations for the mic clip.
Steps to verify the radio's operational status and performance after installation.
Explains that the radio is microprocessor controlled and can be customized.
Instructions on turning on the mobile radio and adjusting volume.
Describes how the radio selects the last used channel and how to change it.
Explains the function of the PTT key for transmit/receive modes.
Details the transmit timer and its warning function.
Explains mute functions and how to use the monitor key.
Steps to set the radio to scan a predefined list of channels.
Explains dual priority scan configured via programming software.
Steps to follow to make a Selcall.
How the radio indicates and how to accept/reject a Selcall.
Explains how group calls are received and if a response is needed.
Details on sending and receiving emergency calls using Selcall.
How the radio may be programmed to conserve battery power.
Guidance for power-related troubleshooting and contacting dealers.
Step-by-step instructions for removing the radio from its cradle.
Important safety warnings related to radio operation and use.
Lists the components of the T2000 II mobile radio unit.
Lists the recommended tools for installation.
Guidance on inspecting the vehicle and planning the installation.
Advises on safe mounting positions and avoiding passenger hazards.
Instructions on how to remove the radio from its cradle.
Details on marking, drilling, and securing the mounting bracket.
Instructions on how to reassemble the radio cradle.
Recommends positions for chassis earth type antennas.
Covers connecting external speakers and the power cable.
Details on connecting external wires and installing the remote control head.
Explains grounding requirements and mounting for the microphone clip.
Steps to verify radio operation and performance after installation.
To Next Page
General
