18
NORMAL OPERATION
•
• Flow rate to keep the water heater running : 1.8 LITRES per minute
WITHOUT REMOTE CONTROLLER
1. Open a cold water tap. 2. Mix hot water with the cold
water to get the suitable temper-
ature water.
. Close the water taps.
NOTE: The water temperature is set at from the factory*. If you want to change the set
temperature of hot water without remote controller, refer to diagram below.
WARNING
• Water temperatures above 50 °C can cause severe burns or death from scalding.
Children, the disabled and the elderly are at a high risk of being injured. Feel the
water temperature before bathing or showering. Do not leave children, disabled
persons, or the elderly unsupervised. The Australian Standards AS 3498 gives full
-
lets (bathrooms) and is required to be conformed to under all plumbing codes
within Australia.
• -
40°C
60°C MODEL
DEFAULT
60°C
45°C
55°C
Temperature settings
50°C MODEL
DEFAULT
50°C
OFF
ON
TMP1
TMP2
TMP3
8 7 6
TMP1
TMP2
TMP3
OFF
ON
8 7 6
TMP1
TMP2
TMP3
OFF
ON
8 7 6
TMP1
TMP2
TMP3
OFF
ON
8 7 6
TMP1
TMP2
TMP3
OFF
ON
8 7 6
WARNING
• -
• Only change the switches with dark squares.
• DO NOT adjust other switches.
•
*NOTE:
To Next Page
Loading...
Need help?
General
