19
Installation
● Assembling the Arm Unit
1.Insert the arm shaft into the post.
*This step is better to be carried out by at least
two people otherwise the arm unit will possibly
be dropped.
OM8-T29
Insert
OM8-T30
Screws
Tighten
2.Using the accessory 4 mm hexagonal wrench,
tighten the two screws in the post.
OM8-T31
Tighten
● Installing the Coupling Unit
*Use the XY coupling specied by our company.
1.Turn the vertical movement locking handle
clockwise, securing the counter-balanced arm
in place.
To Next Page
Loading...