Takagi OM-8 - Page 26

To Next Page

To Previous Page

Installation

OM8-T32

Insert

OM8-T33

Lockingscrew

Washer

plug

2.Put the X-Y coupling unit's (Universal coupling

unit's) attaching shaft through the counter-

balanced arm's boss, fit the washer and plug

onto the shaft.

・Place the plug so that the two locking screws

are on its upper side.

3.Tighten the two locking screws with accessory

1.5 mm hexagonal wrench, securing the X-Y

coupling unit in place.

OM8-T31

Tighten

● Installing the Microscope Unit

*Use the microscope unit specified by our

company.

1.Turn the vertical movement locking handle

clockwise, securing the counter-balanced arm

in place.

OM8-T34

Insert

Suspensionarm

2.Insert the shaft of the XY coupling unit (or the

Universal coupling unit) into the suspension

arm's boss rmly.