Takagi OM-8 - Page 27

21
Installation
OM8-T35
Tighten
Boltwithhexagonal
head
Boltwithhexagonal
head
Tighten
3.Align the direction of the suspension arm so
that the binocular microscope unit and X-Y
centering switch of the X-Y coupling unit (or
the level indicator of the Universal coupling
unit) face the same direction.Then tighten the
two hexagonal bolts with the 4 mm hexagonal
wrench, securing the suspension arm.
OM8-T36
②Tighten
Alignmentscrew
①Insert
● Installing the Binocular
1.Align the binocular unit with the alignment
screw on the microscope unit's attachment
mount and insert it. Then secure it by tightening
the set screw.
OM8-T37
Lightguide
Lightguidesleeve
Insert
● Attaching the Light Guide
1. Insert the light guide in the light guide sleeve
(at the back of the microscope unit).