Takagi OM-8 - Page 28

To Next Page

To Previous Page

Installation

OM8-T38

Tightenthe

lockingscrew

OM8-T39

Loosen

2.Tighten the locking screw with 1.5 mm

hexagonal wrench, secure the light guide in

place.　

Removefourscrews

OM8-T40

● Attaching the Cables

・Removing the counter-balanced arm's cover

1.Turn the vertical movement lock handle

counterclockwise, remove the handle.

2.Remove the four screws on the arm's cover with

a screwdriver.

3.Remove the arm's cover, and attach the vertical

movement locking handle again to the arm,

then turn it clockwise until it stops, securing the

balance arm in place.

OM8-T41

1.Removethearm'scover

2.Attachthehandle