3-3
OPERATION
STARTING AND STOPPING
THE ENGINE
BEFORE STARTING THE ENGINE
1. Adjust the seat for a comfortable operating
position.
2.
Fasten the seat belt.
STARTING AND STOPPING THE ENGINE
3. Check that the safety lock lever is in the
locked position.
4.
Check that all levers and pedals are in the
neutral position.
5. Insert the key into the starter switch, turn it
to the ON position, then perform the
following inspections:
·
All warning lamps flash for one second
and an alarm is sounded for ten
seconds. The meters also start
functioning. After two seconds, only the
battery charge war
ning lamp (3), the
engine oil pressure warning lamp (2) and
the engine emergency lamp (1) start
flashing, and the other lamps turn off.
· Press the light switch to check that the
boom light, front light and meter lights
turn on.
If a lamp does not light or the alarm is not
sounded, the bulb may be burnt out or a
wire may be damaged. Ask a Takeuchi
service agent for repair.
To Next Page
Loading...
Need help?
General
