Takeuchi TB260 User Manual

2-75
CONTROLS
Resetting
If there are any problems, such as the
abnormal display of frequency or failure of
selection, reset the radio by pressing the “4”
button while pressing the AST button and
the AUX button together. Then, “JP” and the
clock display appear on the LCD, indicating
that the radio is turned off. Note that the
memory stored in the preset button is
cleared.
Switching the volume mode when the
radio is on
Switch the modes between SU and FI by
pressing the (1) button while pressing the
AST and AUX buttons together, when the
radio is on.
The SU or FI display appears on the LCD,
followed by the radio turning off by itself.
SU mode: .....The volume at power-off is
retained.
FI mode: .......The volume at power-off is
reset.
ACCESSORIES
SPECIFICATIONS
Power source: .... 12/24 VDC (negative
ground)
Maximum power consumption:
........................... 3A or less (at max. volume,
24 V)
Maximum output power:
........................... 16 W + 16 W (4Ω) (at 28.8
VDC input)
5W+5W (4Ω) (at 14.4 VDC
input)
Rated output power:
........................... 12 W + 12 W (10%
distortion, 4Ω) (at 28.8
VDC input)
3.5 W + 3.5 W (10%
distortion, 4Ω) (at 14.4
VDC input)
Dimensions: ........ 178 (W) x 50 (H) x 65 (D)
mm (excluding protrusions)
Receiving frequency:
........................... MW (AM) 531 to 1602 kHz
(Europe, Asia), 530 to
1710 kHz (North, Central
and South America)
FM 87.5 to 108 MHz
(Europe, Asia), 87.9 to 108
MHz (North, Central and
South America)
Practical sensitivity:
........................... MW (AM) 32 dB or less
(S/N 20 dB)
FM 12 dB or less (S/N 30
dB)
S/N ratio: ............ MW (AM) 40 dB or more
FM 50 dB or more
AUX-IN: .............. Stereo mini jack (3.5 mm);
rated input, 90 mV; 20 kΩ
impedance
Note: Specifications and dimensions may be
changed without notice.

Takeuchi TB260 Specifications

General

Brand	Takeuchi
Model	TB260
Category	Excavators
Language	English