2-44
CONTROLS
10. Select a Band
Press AM/FM (10) momentarily to directly
access tuner mode from any other function
mode. When the unit is already in tuner
mode, briefly press AM/FM to change
between two AM bands (AM1 and AM2) and
three FM bands (FM1, FM2 and FM3).
Note: If the unit is programmed for European
operation, the sequence will be MW1, MW2,
FM1, FM2 and FM3.
11. Manual Tuning
Press TUN– (11a) or TUN+ (11b) momentarily
to tune the frequency one step higher or
lower. Press and hold TUN+ or TUN– for
more than one second to tune continuously
in the selected direction until the button is
released.
12. Seek Tuning
Press SEEK– (12a) or SEEK+ (12b)
momentarily to automatically tune the
frequency down or up to the next strong
station.
13. Preset Stations
Six numbered preset buttons (13) store and
recall stations for each AM and FM band. To
store a station, select a band (if needed),
then select a station. Hold a preset button
for three seconds. The current station will be
stored, and the corresponding preset
number will appear in the display. To recall a
station, select a band (if needed). Press a
preset button momentarily, and the unit will
tune to the corresponding stored station.
Note: Preset buttons recall channels 1-6 on
weather band and cannot be set by the user.
ACCESSORIES
To Next Page
Loading...
Need help?
General
