Takex F71 Series - Environmental Specification

Environment
Incandescent lamp: 10,000 lx max. / Sunlight: 20,000 lx max.
1-3 adjacent units in operation: −25 - ＋55 °C
4-10 adjacent units in operation: −25 - ＋50 °C
11-16 adjacent units in operation: −25 - ＋45 °C
Storage: −40 - ＋70 °C (non-freezing)
35-85%RH (non-condensing)
IP40
Power supply line: 500 V / Cycle: 10 ms / Pulse duration: 1 μs
Radiation: 1 kV / Cycle: 10 ms / Pulse duration 1 μs (with noise simulator)
10-55 Hz / 1.5 mm amplitude / 2 hours each in 3 direction
100 m/s2 / 3 times each in 3 directions
1,000 VAC for 1 minute
500 VDC, 20 MΩ max.
F71series
■ Rating/Performance/Specification
■ Environmental Specification
Model
Power supply
Current
consumption
Control
output (*)
Stability
output (*)
Operation mode
Timer
Response time
NPN type
PNP type
NPN type
PNP type
NPN type
PNP type
NPN type
PNP type
F71R
F71RPN
F71G
F71GPN
F71B
F71BPN
F71W
F71WPN
F71RH
F71RHPN
F71GH
F71GHPN
F71BH
F71BHPN
F71WH
F71WHPN
12-24V DC ±10％ / Ripple 10％ max.
35 mA max.
40 mA max.
Open collector output / Rating: sink current 100 mA (30 VDC max.) / Residual voltage: 1 V or less
Open collector output / Rating: source current 100 mA (30 VDC max.) / Residual voltage: 1 V or less
Open collector output / Rating: sink current 100 mA (30 VDC max.) / Residual voltage: 1 V or less
Open collector output / Rating: source current 100 mA (30 VDC max.) / Residual voltage: 1 V or less
Light-ON/Dark-ON selectable
On delay/off delay/disabled selectable
Delay time: about 40 ms fixed
With switch at 4 (turbo function disabled): 250 μs max.
With switch at 8 (turbo function enabled): 500 μs max.
30 μs max. (*1)
Rating/performance
Output mode
Specification
Light source
(wavelength)
Indicator
Volume (VR)
Switch (SW)
Anti Mutual Interference
Short circuit protection
Material
Connection
Mass
Accessory
Operation indicator: orange LED / Stability (STB) indicator: green LED
SENS: sensitivity adjustment volume (8-turn without stopper equipped with indicator)
●
Light-ON/Dark-ON selector switch: L.ON for Light-ON, D.ON for Dark-ON
●
Timer selector switch: NOR. for ON/OFF operation, ON.D for on delay (40 ms), OFF.D for of delay (40 ms)
Provided
Polycarbonate
Permanently attached cord (outer dimension: dia. 4.8) 0.2sq. 4 core 2 m length (-J type: M8 connector *2)
Approx. 90 g (including 2-m cord and mounting bracket)
Ambient light
Ambient
temperature
Ambient humidity
Protective structure
Noise
Vibration
Shock
Dielectric withstanding
Insulation resistance
Red LED
(660mm)
――――――
●
Anti Mutual Interference/turbo mode selector switch (common)
8:Anti Mutual Interference for up to 8 units, turbo function enabled
4:Anti Mutual Interference for up to 4 units, turbo function disabled
Green LED
(525mm)
Blue LED
(470mm)
White LED
Red LED
(660mm)
Green LED
(525mm)
Blue LED
(470mm)
White LED
(*) Avoid the transient condition (0.5 seconds) immediately after power-up for output.
(*1) The detecting distance for high-speed response H type is reduced to roughly 30% of the ordinary type.
(*2) For details about −J (M8 connector type), see p. 23.
――――――
Provided
Mounting bracket / Screwdriver for adjustment / Light shielding sticker (excluding H type) / Operation manual