In frequency mode, scan for analog
sub-tones set by other transmitters on the
current frequency; the scan will
automatically stop when one is found.
(Not available in channel mode)
In frequency mode, scan for digital
sub-tones set by other transmitters on the
current frequency. (Not available in
channel mode)
If using the scan for analog sub-tone or
digital sub-tone function, once a sub-tone
is detected, it is automatically saved as the
receive and transmit sub-tone for the
current frequency.
Scanning for analog or digital sub-tones
will automatically save the detected
sub-tone as the receive sub-tone for the
current frequency.
When scanning for analog or digital
sub-tones, the detected sub-tone is
automatically saved as the transmit
sub-tone for the current frequency.
Directly input
frequencies from
00.000 to 99.995
using the keyboard.
In frequency mode, the difference
between the transmit and receive
frequencies can be adjusted (whether an
offset is applied is controlled by the offset
direction setting).
In frequency mode, turn off the offset
between the transmit and receive
frequencies; it is off by default.
In frequency mode, the transmit
frequency is equal to the receive
frequency plus the offset frequency,
To Next Page
Loading...
