typically used for accessing repeater
stations.
In frequency mode, the transmit
frequency is equal to the receive
frequency minus the offset frequency,
typically used for accessing repeater
stations.
2.5K、5K、6.25K、10K、
12.5K、20K、25K、30K、
50K
In frequency mode, pressing the up or
down key changes the step value of the
frequency.
In frequency mode or channel mode,
select the channel number to save. If "CH"
is displayed, it indicates the channel is
already saved, and the current channel will
be overwritten.
Default settings:
Channels 1-10,
Workgroups 1-10,
Repeaters 1-10.
You can assign a name to the current
channel or customize it through
programming software.
Delete the stored information of the
current channel; if "CH-001" is displayed,
it means the channel is already saved. If
"001" is shown, the channel is free and has
no stored information, making the
operation invalid.
If the current channel needs to be
included in the scan, it should be set to
"add" status.
If the current channel should not be
scanned, set it to "delete" status.
To Next Page
Loading...
