Talkpod A36plus - Troubleshooting; Power On and Sound Issues

All rights reserved. © 2012-2023 Shenzhen Talkpod Technology Co., Ltd.
Troubleshooting
Fault
Description
Analysis
Solution
Failure to
power on.
Battery may be incorrectly
installed.
Remove the battery and
reinstall it.
Battery may be depleted.
Remove or replace the
battery.
Poor battery contact due
to dirt or damage.
Clean the battery contacts.
If the issue persists,
contact your dealer or
authorized service center
for inspection and repair.
Weak,
intermittent,
or no sound
during
reception.
Low battery voltage.
Charge or replace the
battery.
Low volume.
Increase the volume by
rotating the volume
control knob.
Loose or improper
antenna installation
Reassemble the antenna
properly after turning off
the radio.
Speaker may be blocked
or damaged.
Clean the speaker surface.
If the issue persists,
contact your dealer or
authorized service center
for inspection and repair.
Unable to
communicate
with other
members.
Frequency or signaling
settings may be
inconsistent with other
members in the group.
Set the same frequency
and signaling as other
members in the group.
Too far away from other
members in the group.
Get closer to other
members.