User guide Table of contents
III
Selecting start signal for escape sequence (ESCChar) 63
Selecting emulation (Emulate) 64
Bidirectional printing (Bidir) 64
Settings for interfaces (I/O) 65
Serial interface (Serial) 65
Data transmssion rate (Baud) 65
Data format (Format) 66
Further Settings (Special) 67
Error handling (ErrMode) 67
Block end character (Blockend) 67
Signal feedback (Remote) 68
Transparence (Handthr) 68
Protocol (Protocol) 69
Signal Processing (DTR) 69
Selecting interface (Interf.) 70
Interface buffer (Buffer) 70
Ethernet interface
(ETH-INT) 71
Setting IP address (IP Addr) 71
Setting Gateway address (Gateway) 71
Setting Subnet mask (Subnet) 72
IP address administration
(IP Get M) 73
Banner page (Banner) 73
Ethernet speed (EthSpeed) 74
Selecting character set
(CG-Tab) 75
IBM character set (CharSet) 75
National character set (Country) 76
Slashed zero
(Sl.Zero) 76
Automatic carriage return (Auto-CR) 77
Automatic line feed
(Auto-LF) 77
Menu lock (MenLock) 78
Language (Language) 78
Paper parameters (Paper) 79
Form length (Forml) 79
First printing position (FormAdj) 81
Printhead gap manually (Head) 82
View and tear position (AutoTear) 83
To Next Page
Loading...
