The mincer/grinder makes
strange noises.
The worm is jammed by a foreign object.
Dismantle the worm/cutting set assembly following
the instructions in section 8.2 of this manual and
remove the foreign object that is jamming the
worm.
Possible aberrations in the gears, motor-
reducer, or the reducer bearings.
Have the distributor check the condition of the
gears, reducer, motor, and reducer bearings.
Oil stains present on the
lower part of the machine.
The gear reducer is leaking oil.
Notify your distributor’s technical service
department.
Warning! ALWAYS power off and unplug the machine when resolving any problem. In the event your
technician is unable to resolve the difficulty, DO NOT CONTINUE TO USE THE MACHINE and contact your
authorized TALSA dealer for service.
To Next Page
Loading...