Tanaka TCS 40EA - English; Table of Contents

English
3
MEANINGS OF SYMBOLS
NOTE: Some units do not carry them.
Symbols
WARNING
The following show symbols used for the machine. Be sure that you understand their meaning
before use.
It is important that you read, fully
understand and observe the following
safety precautions and warnings.
Careless or improper use of the unit may
cause serious or fatal injury.
Emergency stop
Read, understand and follow all warnings
and instructions in this manual and on the
unit.
Fuel and oil mixture
Always wear eye, head and ear protectors
when using this unit.
Chain oil fi ll
Warning, kickback danger. Be careful of
possible sudden and accidental upward
and/or backward motion of the guide bar.
Carburetor adjustment - Idle speed
One-handed usage not permitted. While
cutting, hold saw fi rmly with both hands
with thumb fi rmly locked around front
handle.
Carburetor adjustment - Low speed
mixture
Chain brake
Carburetor adjustment - High speed
mixture
Choke Oil pump adjustment
On/Start Priming pump
Off /Stop
Computed kickback angle (CKA) without
a chain brake
Contents
WHAT IS WHAT?...................................................4
WARNINGS AND SAFETY INSTRUCTIONS .......5
SPECIFICATIONS ................................................. 7
ASSEMBLY PROCEDURES .................................8
OPERATING PROCEDURES ............................... 9
MAINTENANCE .................................................. 15
Parts breakdown
000BookTCS40EAUS.indb3000BookTCS40EAUS.indb3 2012/08/109:30:372012/08/109:30:37