What to do if my Tangent EXEO AMP Amplifier has no sound?
If your Tangent Amplifier has no sound, ensure the unit is turned on and the volume isn't set to minimum or muted. Check the speaker cables for correct connection, verify the input source is correctly connected and selected, and confirm the speaker setting is not set to off.
How to fix Tangent EXEO AMP when it has no power?
If your Tangent Amplifier has no power when turned on, ensure the current is switched on at the mains outlet socket and the plug is correctly inserted. If these steps don't resolve the issue, the internal fuse may have blown or the power cord may be damaged, requiring replacement by a qualified service technician.
Why is there sound in only one channel of my Tangent EXEO AMP?
If you're only getting sound in one channel of your Tangent Amplifier, check the balance control to ensure it's correctly adjusted. Also, inspect the audio input and speaker cables for incorrect connections or damage. The input source or speaker itself may also be defective.
What causes distortion of sound in Tangent EXEO AMP Amplifier?
Sound distortion in your Tangent Amplifier can occur if the bass and treble controls are set too high relative to the speaker specifications, or if the volume is set too high.
Why does my Tangent EXEO AMP have weak bass and poor stereo perspective?
A weak bass and poor stereo perspective in your Tangent Amplifier could be due to the speaker connection being out of phase. Verify that the positive and negative poles are correctly connected both at the back of the amplifier and at the back of the speaker.
How to eliminate high buzzing sound from Tangent EXEO AMP Amplifier?
To eliminate a high buzzing sound from your Tangent Amplifier, check the audio input cables for incorrect connections or damage. Ensure the ground cable for the record player is connected. The turntable pick-up could also be defective.
What to do if the Tangent EXEO AMP Amplifier display doesn't show any information?
If the display on your Tangent Amplifier is not showing any information, it could be that the time out for the display is chosen in the menu, or the amplifier may be defective and require servicing by a qualified technician.
What to do if Tangent Amplifier unit does not switch between inputs?
If your Tangent Amplifier unit does not switch between inputs, the amplifier is defective and should be serviced by a qualified technician.
What does it mean when “ERROR” is displayed on Tangent EXEO AMP Amplifier?
If “ERROR” is displayed on the display of your Tangent Amplifier, the amplifier is defective and should be serviced by a qualified technician.
General| Type | Integrated Amplifier |
|---|---|
| Frequency Response | 20 Hz - 20 kHz |
| Signal-to-Noise Ratio | > 100 dB |
| Input Impedance | 47 kΩ |
| DAC | Yes |
| Power Output | 2 x 50W (8 Ohms) |
| Inputs | RCA |
| Outputs | Speaker |
| Input Sensitivity | 200 mV |
To Next Page
