05/06
Power
Touch the power button to turn the unit on/off. When the device is in
standby mode tap on the Sleep Mode button to change the tempera-
ture display. The ambient temperature will be shown in Fahrenheit by
default. Tap again to switch to Celsius.
Note: The temperature display can't be changed when the device is
working.
Mist Output
When the unit is powered on, touch the Mist Output button to cycle
through the 3 mist output levels.
Warm Mist
Touch the Warm Mist button and the humidier will heat the mist.
Note:
• It will take up to 30 minutes for the mist to warm up. Warm mist can
increase humidifying speed by 15- 20%, but it uses more power than
cool mist.
• When warm mist is on, do not hold your hand in the mist to avoid
burning. Keep an eye on children.
Timer
Touch the Timer button to set an automatic timer between 1 to 9 hours.
Select CH to disable the timer. Once selected, the timer icon will ash 4
times to conrm.
Control Panel
%
• To continue using the humidier, unplug the power plug and ll the
water tank with clean water. Drain out any residual water before lling
the water tank with clean water
Note: When moving the humidier, please unplug the power plug and
move the entire unit together. Do not move the unit when it is working.
To Next Page
Loading...
Need help?
General
