17 18
• For storage, you may leave the heater covered to protect it from
dust. Store it in a cool, dry location and wrap the cord around the
cord wrap on the unit so that it will not be tripped over or damaged.
Caution:
• Do not allow water to run into the interior of the heater as this could
result in a fire or electric shock hazard.
• Any other servicing should be performed by an authorized service
representative.
Troubleshooting
The following troubleshooting guide addresses the most common
problems. If problems persist, contact the Customer Support at
support@TaoTronics.com.
Problem
Possible
Causes
Solution
Heater does
not start
Power cord is
not properly
plugged in.
Connect the plug to a powered
electrical outlet.
Overheat
Protection has
been activated.
Turn the heater OFF, unplug it
and allow it to cool.
Check and remove any objects
on or adjacent to the heater.
Wait 5-10 minutes before
plugging the unit back in.
No power
is passing
through the
unit.
Ensure that your circuit breaker
or fuse is working properly.
Ensure your heater is placed on
a flat and even surface.
Setting
temperature
is lower than
the room
temperature.
Make sure the thermostat is set
at a higher temperature than
the room temperature.
To Next Page
Loading...
Need help?
General
