Why does my TaoTronics Heater suddenly stop during heating?
If the TaoTronics Heater suddenly stops during heating, it might be because the temperature has exceeded the thermal cut-off threshold. To resolve this, turn off the unit, unplug it from the power outlet, allow it to cool down, and then plug it back into the electrical outlet.
What to do if Overheat Protection has been activated on TaoTronics Heater?
If the Overheat Protection of your TaoTronics Heater has been activated, turn the heater OFF and unplug it to allow it to cool down. Check for and remove any obstructions on or around the heater. Wait 5-10 minutes before plugging the unit back in.
Why is no power passing through my TaoTronics Heater?
If your TaoTronics Heater isn't powering on, first ensure that your circuit breaker or fuse is functioning correctly. Also, make sure that the heater is placed on a flat and even surface.
What to do if setting temperature is lower than the room on TaoTronics Heater?
Ensure that the thermostat on your TaoTronics Heater is set to a temperature higher than the current room temperature.
Shows the setting temperature, heat level, or Auto Start/Stop time.
Instructions for turning the heater on and off via control panel or remote.
How to adjust the heat level (H3, H2, H1) using the control panel or remote.
Details on adjusting the operating temperature from 40-95°F in 1°F increments.
Guides for setting auto stop and auto start timers for the heater operation.
Instructions for activating and using the energy-saving ECO mode.
Describes automatic shut-off mechanisms for overheating and tipping.
General| Power | 1500W |
|---|---|
| Heating Method | Ceramic |
| Safety Features | Overheat protection, Tip-over switch |
| Voltage | 120V |
| Color | Black |
| Thermostat | Adjustable |
| Heat Settings | High, Low |
| Oscillation | Yes |
| Heating Modes | High Heat, Low Heat, ECO Mode |
To Next Page
