11 12
Operations and Functions
Plug the heater into an appropriate voltage AC outlet, the unit will
enter standby mode with a beep and power indicator on red.
LED Display
• Shows the setting temperature (40-95°F), heat level (H3, H2, H1) or
Auto Start/ Stop time (00-24H) while setting.
Power ON
• Press once to turn the heater ON: Power indicator turns green &
highest heat level “H3” flashes on LED display, then setting
temperature is displayed after 3 second.
Power OFF
• Via Control Panel: Repeatedly press to OFF, or press and hold it
for 2 seconds.
• Via Remote Control: Press once again.
Heat Level Setting
• Via Control Panel: When the unit is on, repeatedly press to cycle
through H3 -> H2 -> H1 -> OFF -> H3 with setting temperature
displayed after 3 second.
• Via Remote Control: When the unit is on, press to adjust the heat
level (H3, H2, H1)
Temperature Adjustment
• When the unit is on, press the or Button to adjust the
temperature from 40-95°F in 1°F increments.
• Press and hold the buttons to quickly skip to the desired
temperature. The set temperature will flash three times to confirm
your setting.
• When the setting temperature is reached, the heater may keep
working for additional minutes to maintain the setting temperature.
• Default setting temperature: 86°F
Timer Setting
• Auto Stop Timer: When the unit is ON, press the Timer Button, then
press the or Button to set the number of hours (00-24H) you
want the unit to run before it switches off. When time is up, the unit
will automatically stop running.
• Auto Start Timer: When the unit is OFF (with the heater plugged into
an electrical outlet), press the Timer Button, then press the or
Button to set the number of hours (00-24H) you want the unit to start
running automatically. When time is up, the unit will automatically
start running.
To Next Page
Loading...
