11 12
Replacement of Batteries in
Remote Control
1.Remove the battery box cover along the indicated arrow direction.
2.Replace with two new #7 (AAA 1.5V) dry batteries. Make sure posi-
tions for “+” pole and “-” pole are correct.
3.Reinstall the battery box cover.
CAUTION:
• Replace with new batteries of the same type when replacement is
required.
• When not using the remote control for a long time, please take out
the batteries.
• Do not attempt to dismantle the batteries.
• Do not dispose the batteries in fire, batteries may explode or leak.
Other Features
Memory Function
• If power is not disconnected, the heater will always remember your
last settings (temperature & working mode) once you turn it on
again.
24-Hour Auto Shut Off
• When the heater has been working for 24 hours continuously
without any other operation, it will shut off automatically.
Tip-Over Protection
• When the heater is tipped over, the heater will shut off automatically
with malfunction code “P4” on LED display and beeps.
• Place the heater back on a flat, level and stable surface and remain
upright. Then turn it on again.
Overheat Protection
• When the ambient temperature is above 50°C / 122°F, the heater
will stop heating and the overheat alarm will be triggered with
malfunction code “FF” on LED display and beeps
• Please unplug it from the power source and power it on again when
the ambient temperature drops below 50°C / 122°F.
To Next Page
Loading...
