12
Programming Faceplate
You will need to programme the faceplate with the time and hardness
of the water.
When the transformer is first plugged in, the display will flash 12.00am.
Note: Each time you press a button on the fascia panel display, a
beeper sounds. One beep signals that a change is accepted. If the
beeper sounds continually then a different button is required to
affect the operation.
SET THE PRESENT TIME
The display will continue to flash and
the time can be advanced or moved
backwards using the or buttons.
Holding down the buttons advances
the time at a faster rate.
If the time requires resetting during normal operation, press the SELECT
button once. The display will flash and indicate present time. You may
use the or buttons as described above to alter the time. Once the
required time is displayed the time may be set by pushing the SELECT
button once more.
Please Remember – Only use tablet or pellet salt in your softener!
To Next Page
Loading...
Need help?
General
