10
Fitting drain and overflow hoses
DRAIN OUTLET/OVERFLOW CONNECTION
See page 5 on drain and overflow before fitting.
Cut tubing for drain and overflow to the required lengths.
Fitting overflow hose
Insert the rubber grommet into the overflow socket situated 2/3 of the
way up the rear of the water softener cabinet, using the slilcone grease
provided. Insert the overflow elbow. Fit hose onto the overflow elbow and
secure with metal clamp. Pass the overflow through an outside wall so
that the end can be seen.
Fitting drain hose
Turn the drain line adaptor so that a straight connection can be made.
Secure with supplied metal clamp. The drain hose may be connected
directly into an open drain or via the waste outlet similar to a washing
machine. When connecting to a drain the regulation air gap is required
to prevent backflow. Make sure the hose is not kinked as this will stop
the operation of the softener.
Please Remember – Only use tablet or pellet salt in your softener!
To Next Page
Loading...
Need help?
General
