Tapworks AD11 User Manual

Programming
Please Remember – Only use tablet or pellet salt in your softener!
12
Programming the Ultra 9 Faceplate
When the transformer is first plugged in, the display will flash 12.00am.
Note: Each time you press a button on the fascia panel display,
a beeper sounds. One beep signals that a change is accepted. If the
beeper sounds continually then a different button is required to affect
the operation.
SET THE PRESENT TIME
The display will continue to flash and the time can be advanced or
moved backwards using the s or t buttons. Holding down the
buttons advances the time at a faster rate.
If the time requires changing during normal operation, press the SET
button once. The display will flash and indicate present time.
You may use the s or t buttons as described above to alter the
time. Once the required time is displayed the time may be set by
pushing the SET button once more.
SET THE WATER HARDNESS CALCULATION
The display will flash ’25 hardness’ (this is
a pre-set factory setting). Hardness varies
from one location to another. Use the kit
provided to determine your water
hardness in ppm. If necessary change to
the unit setting indicated.
2 5
HARDNESS
ppm Unit Setting
(170) 10
(190) 11
(200) 12
(220) 13
(240) 14
(255) 15
(270) 16
(290) 17
(300) 18
(325) 19
(340) 20
(360) 21
(380) 22
(400) 23
(420) 24
(440) 25
(460) 30
(480) 30
(500) 35
WATER HARDNESS

Tapworks AD11 Specifications

General

Brand	Tapworks
Model	AD11
Category	Water Dispenser
Language	English