User information
Please Remember – Only use tablet or pellet salt in your softener!
14
Programming the Ultra 9 Faceplate
The unit can be programmed to recharge
at the next pre-programmed time,
regardless of its remaining capacity.
This is particularly beneficial to ensure a
sufficient softened water supply for an
unexpected heavy water usage the next
day. Simply press the TOUCH/HOLD
button once. Recharge tonight will flash on
the display, indicating a recharge will
occur at the pre-programmed recharge time. This completes the
instruction. Should you wish to cancel this recharge, press the
TOUCH/HOLD button once and immediately release. The display
will return to the to the time display.
TO RECHARGE NOW
Alternatively a manual recharge can be
initiated at any time. Simply press the
TOUCH/HOLD button and hold it down
for approximately 3 seconds, until a
beep sounds.
Recharge will flash on the display.
The process will take a few minutes to
begin and lasts approximately 1 hour.
It cannot be cancelled once started.
Use as little water as possible during this time period as hard water
will bypass the water softener.
Once a recharge is complete, the recharge now display will
disappear. The present time will be displayed.
Note: The unit will automatically flash ‘recharge tonight’ once the
computer calculates that a recharge is required. This is information
only – no action is required. Once recharge begins, a flashing
‘recharge’ replaces the flashing ‘recharge tonight’.
12
:00
RECHARGE TONIGHT
20
%
WATER MANAGEMENT SYSTEM
CAPACITY
12
:00
RECHARGE NOW
20
%
WATER MANAGEMENT SYSTEM
CAPACITY
To Next Page
Loading...
Need help?
General
