Guarantee, service & general information (cont)
General information
SALT
Salt is used as the cleansing agent for your water softener’s resin bed.
The salt cabinet will need to be refilled from time to time.
It is essential that approximately 6 inches of salt is maintained
as a minimum to ensure operating efficiency.
Failure to replenish salt will prevent the unit from cleansing itself on its
recharge cycle and consequently it will be unable to soften water. Pour the
salt slowly into the cabinet. Ensure that the brine well cap is secure, as no
salt should be allowed to enter here. DO NOT use granular salt.
ONLY USE TABLET SALT OR PELLET SALT.
Your local water softener stockist will stock salt.
HOLIDAYS
We would recommend that you by-pass your water softener if you are away
from your home for long periods of time.
NOTE: During the cleaning process salt does not enter the water supply.
Salt is rinsed to drain.
CLEANING
Your unit may be cleaned with a damp cloth and detergent. Do not use
bleaches, solvents or spirits as this may cause damage.
WATER LEVEL
The water level will vary. Generally there will be no more than two inches
of water in the cabinet. During recharge this will increase. Water may
normally be visible only when the salt level is very low.
PERFORMANCE CHECK-UP
To ensure the efficient operation of your softener, Tapworks recommends
regular servicing. Please call 0870 429 9019 to discuss your
service options.
Please Remember – Only use tablet or pellet salt in your softener!
32
Problem solving
RETURN YOUR REGISTRATION CARD TODAY!
TO BENEFIT FROM YOUR FREE 2 YEAR GUARANTEE
To Next Page
Loading...
Need help?
General
