Need help?Do you have a question about the Taramps Electronics MD3000.1 and is the answer not in the manual?
General| Number of Channels | 1 |
|---|---|
| Operating Class | D |
| Maximum Power @ 12.6 VDC - 1 OHM | 3000W |
| Maximum Power @ 12.6 VDC - 2 OHMS | 1500W |
| Signal to Noise Ratio | >90dB |
| Crossover High Pass (HPF) | 10Hz - 50Hz |
| Input Impedance | 10K OHMS |
| Idle Consumption @ 12.6 VDC | 1.5A |
| Maximum Musical Consumption @ 12.6 VDC | 250A |
| Efficiency | > 85% |
| Power Output (RMS) | 3000W |
| Frequency Response | 10Hz - 20kHz |
| Crossover Low Pass (LPF) | 50Hz - 150Hz |
| Bass Boost | 0 - 12dB |
| Output Impedance | 1 OHM / 2 OHMS |
| Protection System | Short Circuit, Overheating, Overload |
| Maximum Supply Voltage | 16 VDC |
Details recommended wire gauges and protection fuse/circuit breaker sizes for installation.
Welcome message and overview of the manual's scope and purpose.
Provides essential guidelines for optimal amplifier usage and installation safety.
Connects signals from Head Unit using shielded RCA cables to avoid noise.
Adjusts amplifier input sensitivity for optimal output signal levels with various Head Units.
Controls frequency range with High Pass (10Hz-90Hz) and Low Pass (90Hz-18KHz) filters.
Adjusts bass boost center frequency (35Hz-55Hz) and gain (0 to +10dB).
Connects to accessory for monitoring amplifier status via indicator LEDs (Premier model only).
Output for connecting speakers, requires attention to polarity and minimum impedance.
Details for connecting FAN, Positive, Remote, and Negative power supply terminals.
Explains the meaning of ON, CLIP/TEMP, PROT LEDs and their related protection functions.
Specifies nominal output power across different impedances (1, 2, 4, 8 Ohms) at 12.6VDC.
Details input sensitivity (220mV) and signal-to-noise ratio (>90dB).
Defines frequency response (10Hz-18KHz) and crossover filter ranges (HPF/LPF).
Details Bass Boost settings (35Hz-55Hz, 0-10dB) and amplifier efficiency (79%-85%).
Lists protection features: Short-Circuit, Low Impedance, Low/High Voltage, Thermal.
Specifies minimum/maximum supply voltage and idle/musical/rated consumption.
Provides physical dimensions (228x70x218mm) and weight (2.5Kg) of the amplifier.
To Next Page
