144 145
USB-C Dual 4K Docking Station 100W PD w/Legacy Power USB-C Dual 4K Docking Station 100W PD w/Legacy Power
Regulatory Compliance (applicable to products
with electronic circuitry/parts only)
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may notcause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Warranty
3 YEAR LIMITED WARRANTY: We pride ourselves on the quality of our products.
For complete warranty details and a list of our worldwide oces, please visit
www.targus.com
Features and specifications are subject to change without notice. All trademarks
and registered trademarks are the property of their respective owners. All rights
reserved. ©2019 Manufacturer or Imported by Targus Europe Ltd., Fourth Floor,
One London Road, Staines, TW18 4EX, UK. All rights reserved.
Declaration of Conformity
Targus hereby declares that this device is in compliance with the essential
requirements and other relevant provisions of Directive 2014/30/EU.
Targus Recycling Directive
At the end of this product’s useful life please dispose at an appropriate recycling
collection point provided in your country.
FCC Statement
Tested to Comply
This equipment has been tested and found to comply with the limits of a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy, and if not
installed and used in accordance with the instructions may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment o
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna;
• Increase the separation between the equipment and receiver;
• Connect the equipment into an outlet on a circuit dierent from that to which the
receiver is connected;
• Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not authorized by the party responsible for compliance
could void the user’s authority to operate this product.
To Previous Page
Loading...
Need help?
General
