Tascam CD-200SB - Troubleshooting Guide; Common Issues and Solutions

TASCAM CD-200SB
45
10 – Troubleshooting
If you have problems with your system, look through this
chart and see if you can solve the problem yourself before
calling the nearest retailer or TASCAM representative.
8
No power
e Is the unit’s power plug completely inserted into a working
power outlet?
8
Remote control doesn’t work.
e Check to see if the batteries are properly installed in the
remote control.
e If the batteries are dead, change the batteries.
8
No sound
e Check the connection to the monitor system again.
e Check the volume and settings of the amplifier.
8
There is unwanted noise.
e Are the connecting cables all properly connected and
functioning?
8
A CD cannot be played back.
e If you are using a data CD with MP3 files, confirm that the file
bit-rates are compatible with this unit.
e Is the disc scratched or dirty?
8
I cannot play back all the files on a data CD, SD card
or USB flash drive.
e Make sure the unit is not in folder playback mode.
8
I cannot use program playback.
e Make sure the playback area is not set to ALL PLAY .
To use program playback with data CDs, SD cards and USB
flash drives, the playback area must be set to FOLDER .