Tascam DA-30 - Page 20

sie Mtn ss
(V. Gently turn the screws on taps of both guide
rollers alternately counterclockwise so that the
envelope has the shape shown in Fig. 3-10. The
shape of the envelope when the tape is running
outside the drum. lead is shown in Fig. 3-11.
Input side
Fig. 3-10.
V. After the adjustment of the guide rollers is com-
plete, tighten the setscrews (Fig. 3-2) securing the
guide rollers using the hexagonal wrench. (The
tightening torque should be 1 kg.cm.)
After the adjustment is complete, eject the tape, then
load it again and confirm whether or not the envelope
is as shown in Fig. 3-10. If it isn’t, go back to 4, then
perform adjustment again.
After adjustment is complete, check to make sure
the tape is not curled around the guide rollers.
Turn the heads of the P1 and P2 posts counterclock-
wise using the hexagonal wrench, and adjust so that
the lower edge of the tape is positioned correctly
when the tape is running. Adjust so that the tape is
seen to run along the post flange. At this time, see
that the tape is free from curling.
Small deviation
HnB +s
NV. MMowt F+ao-~F-OURODAVEDL IDEM
REREL,
zy<a-SeRB3-WORRBKKET
SZ.
F-TRYYYIS-OV— FROANTEHLTOS
Badr yNa-JORK(, M3-1lORKROEF.
Medium deviation Large deviation
Ans Ane *K
V. HW4 K+ 0-5 -ORER. AML YFRTHI Ks
O-F-EAIELTAS TERY (3-2 ) SHHS,
(HO bald,
eR. -—KEJECTL. Hite -F1v7eipuxrvy
<a-7h, MB-lOOMABKIK Ko TOSD SEBS S.
HetTVEVHRSI, WEIAK Ke CHESTS.
MBATR, WI Fea -F-CFH-THMA-NLTUOG
WO ShHBtTS.
Pl.
= FRM a US.
WB, SACHA VavrYRF-SEMBOUS
BCT AS.
ce.
Kes caDc et)
P2 RAbhOMAZARLYFRCAKEL, 7-7
CODER, F-FOHN-NHKUORCERTS
¢
@