Need help?Do you have a question about the Tascam DA-302 and is the answer not in the manual?
General| Type | Digital Audio Tape Deck |
|---|---|
| Track System | 2-channel stereo |
| Tape Speed | 8.15 mm/s |
| Quantization | 16-bit linear |
| Frequency Response | 20Hz - 20kHz |
| Sampling Frequency | 48kHz |
| Signal-to-Noise Ratio | > 92 dB |
| Total Harmonic Distortion | <0.005% |
| Wow and Flutter | Below measurable limits |
| Output Voltage | 2.0V RMS |
| Dimensions | 482 x 132 x 350 mm (W x H x D) |
| Inputs | XLR, RCA, Optical |
| Outputs | XLR, RCA, Optical |
Specific safety advice for UK, USA, and European users regarding electrical connections and potential hazards.
Covers operational, electrical, and handling safety, including cleaning, placement, and ventilation advice.
Details grounding, polarization, and electrical hazard avoidance measures for safe operation.
Covers safe servicing practices, component replacement, safety checks, and proper mounting procedures.
Steps for analog and digital recording on a single deck, including lead-in mark creation.
Procedures for copying tapes, including subcodes, program order, and mid-tape dubbing.
Recording on multiple decks simultaneously (Dual) or sequentially (Continuous).
Setting up sequential recording across multiple DA-302 units using a single input source.
Simultaneously copying a source to multiple decks and performing sequential playback across units.
Status messages and indicators like NoPGM, Proh, and Not Ready.
Specific error codes (Err 01, 02, 04) and their corresponding troubleshooting steps.
To Next Page
