M
Michael AndersonSep 12, 2025
What to do if my Tascam FW-1884 audio source is an analog input?
- SSusan Baldwin MDSep 12, 2025
If your audio source is an analog input, check whether the channel trim pot adjusted correctly.
What to do if my Tascam FW-1884 audio source is an analog input?
If your audio source is an analog input, check whether the channel trim pot adjusted correctly.
Why is there incorrect surface response on my Tascam FW-1884 Accessories?
If you are running in Mackie Control Emulation or Mackie HUI Emulation protocol, ensure that you have Mackie Control selected in your DAW application. Also, check if you have the correct COMPUTER Control Surface protocol selected in the FW-1884’s Control Panel.
General| Channels | 18 |
|---|---|
| Digital I/O | ADAT, S/PDIF |
| Phantom Power | Yes |
| Bit Depth | 24-bit |
| Control Surface | Yes |
| Rotary Encoders | 8 |
| Transport Controls | Yes |
| Connectivity | FireWire |
| Analog Outputs | 8 |
| MIDI I/O | In/Out |
| Sample Rate | 44.1 kHz, 48 kHz |
| Faders | 8 |
| Type | FireWire Audio Interface / Control Surface |
