Software Overview
Activate this to enter Read Mode (the equivalent to pressing the READ key on
the TM-D4000). Double click it to select Read Mode for all channels.
Activate this to enter Manual Mode (the equivalent to pressing the MANUAL
key on the TM-D4000). Double click it to select Manual Mode for all channels.
Brings up the Automation Items window which allows the selection of the
different mixer parameters which may be automated.
Use these four buttons for the quick enabling/disabling of writing and reading
for the faders and cuts. The red buttons on the left enable/disable writing
while the green buttons on the right enable/disable reading.
Toggles between PFL (Pre-Fader Listen) and IPS (In Place Solo).
3.4 Toolbar/Disk Operations
The Toolbar can be selected for viewing or hidden using the Show Toolbar command in the
View Menu. This is a floating toolbar that can be dragged from the default position and
re-anchored where most convenient. It contains standard icons which, when clicked, carry
out file operations.
NEW: This clears the contents of the current mix and starts a new mix session.
LOAD: This opens the standard Windows dialog box for opening a previously saved
mix session.
SAVE: This saves the current mix session to disk using the standard Windows dialog box.
SAVE AS: This saves the current mix under a new name.
UNDO: This discards the effects of the last mix pass.
REDO: This restores mix information discarded by an UNDO command.
ABOUT: Displays the automation software and TM-D4000 firmware versions.
7
To Next Page
Loading...
Need help?
General
