15
TROUBLESHOOTING - CONTINUED
Problem Cause Solution
Garden hose Loose ttings. Tighten ttings.
connection leaks.
Missing/worn rubber washer. Insert new washer.
Spray wand, or Spray nozzle not properly attached. Insert the spray nozzle into the trigger
extension, or gun. Carefully press in against the
nozzle leaks. spring tension and twist into the
locked position.
Broken o-ring or plastic insert. Call Customer Service.
Pump is noisy. Pump is sucking air. Check that hoses and ttings are air
tight. Turn off machine and purge
pump by squeezing trigger gun until a
steady ow of water emerges through
the nozzle.
Water leaks from Loose ttings. Check that all ttings are tight.
pump (up to 10
Water seals are damaged or worn. Call Customer Service.
drops per minute
is permissible).
Oil Drip. Oil seals are damaged or worn. Call Customer Service.
Motor buzzes Supply voltage below minimum. Verify that only the pressure washer is
but fails to run. running on this circuit.
System has residual pressure. Turn unit “OFF”, squeeze trigger on
spray want to release pressure, then
turn unit “ON”.
Voltage loss due to extension cord. Do not use extension cord with this
unit—plug directly into power outlet.
Pressure washer not used for long periods Call Customer Service.
IF YOU ENCOUNTER ANY ADDITIONAL DIFFICULTIES NOT LISTED, CALL CUSTOMER SERVICE
AT 1-866-990-9918 FOR ASSISTANCE.
To Next Page
Loading...
