Task Force ZE04 - Troubleshooting

TROUBLESHOOTING
14
Problem Cause Solution
Motor will not start GFCI needs to be reset. Press RESET button on the GFCI.
On/Off switch is in the “OFF” (O) position. Turn switch to the “ON” ( | ) position.
Power cord is not plugged in. Plug in power cord.
Extension cord is too long. Replace extension cord with one no
Extension cord is not proper gauge. greater than 14AWG, 50ft.
Extension cord is damaged.
Electrical outlet does not supply Try a different outlet.
adequate power.
Unit does not reach Diameter of garden hose is too small. Replace with an inch or 5/8 inch
garden hose.
Water supply is restricted. Check garden hose for kinks, leaks
and blockage.
Not enough inlet water supply. Open water source full force.
Water inlet lter is clogged. Remove lter and rinse out in
warm water.
Pump is sucking air. Check that hoses and ttings are air
tight. Turn “OFF” machine and purge
pump by squeezing trigger gun until a
steady ow of water emerges through
the nozzle.
Output pressure Not enough inlet water supply. Turn water on full force. Check garden
varies high and low hose for kinks, leaks or blockage.
Pump is sucking air. Check that hoses and ttings are air
tight. Turn “OFF” machine and purge
pump by squeezing trigger gun until a
steady ow of water emerges through
the nozzle.
Water inlet lter is clogged. Remove lter and rinse out in warm water.
Discharge nozzle is obstructed. Blow out or remove debris with a
ne needle.
No detergent. Detergent container is empty. Add more detergent.
Detergent bottle or suction tube Check connections.
not properly connected.
Detergent is too thick. Dilute detergent
Filter on detergent suction tube Run warm water through lter
is clogged. to remove debris.
Damaged or clogged detergent Remove obstruction or replace
suction tube. detergent suction tube.
Discharge nozzle is obstructed. Turn nozzle tip to low-pressure position.
Blow out or remove debris with a
ne needle.